Why 192.168.1.1 IP is Not Working? How to Fix it!

192.168.1.1 is the default IP offered by Netgear to help its users to configure their Netgear router in a jiffy. Although the process of setting up a Netgear router via 192.168.1.1 is not rocket science, still some users find the process a bit difficult using the IP. On the off chance if you are also struggling with the 192.168.1.1 IP not working issue, then walking through the fixes listed in this post can be of great help to you. So what are you waiting for? Without much delay, keep scrolling down!

Here’s how to Fix 192.168.1.1 IP Not Working Issue

Fix 1: Power Cycle Your Netgear Router

The very first tip that you can try in order to get rid of 192.168.1.1 IP not working issue is to power cycle your Netgear router. The process can be done easily by unplugging your router from its wall socket and plugging it back in again after a couple of seconds. Once you’re done, try accessing the router login page using the 192.168.1.1 IP and see whether it works for you are not. But, prior to power cycling or rebooting your Netgear router, don’t forget to disconnect it from the modem, PC, laptop, or mobile devices (if connected).

Fix 2: Check the Cable Connections

You may not be able to access the router login page using 192.168.1.1 IP if there is some issue in the connectivity of your router and modem. Thus, make sure that the cable connections made by you between your Netgear Nighthawk router and modem are proper and finger-tight. Apart from that, if you find the Ethernet cable connected to your devices is damaged, change it right away.

Note: You can also use a wireless connection to connect your Netgear Nighthawk router and the modem.

Fix 3: Update the Internet Browser

Bear in mind – if an outdated internet browser has been using by you to access the router login page using 192.168.1.1 IP, then it is obvious to face the issue. 192.168.1.1 IP only works on an up-to-date internet browser. Hence, to get rid of 192.168.1.1 not working issue, update your internet browser to the latest version. Additionally, it is also suggested to erase all the junk files and browsing history from your internet browser prior to accessing 192.168.1.1 IP.

Fix 4: Change the Location of Your Nighthawk Router

If your Nighthawk device is placed near to interference-creating devices like Bluetooth speakers and baby monitors, then it can also stop you from accessing 192.168.1.1 IP. Thus, it is advised to place Nighthawk router away from devices emitting radio waves. Ideally, you must place your Nighthawk device at the center-most area of your home, away from corners and windows.

Bonus – To get the most out of your Nighthawk router, please do not place it on a non-ventilated or congested area like inside a cupboard or under a table.

Fix 5: Temporary Disable Ad-Blocking and Firewall Apps

Installation of some apps can also be a cause behind 192.168.1.1 IP not working issue. To get it fixed, disable the proxy, firewall apps, and ad-blocking software temporarily. Doing so will somehow help you fix 192.168.1.1 IP not working issue.

Fix 6: Update the Router’s Firmware

Chances are that the firmware version on your Nighthawk router is outdated and that is why you are facing 192.168.1.1 not working issue, In order to fix the problem, consider updating the firmware of your device by navigating to Nighthawk router login page and following the on-screen instructions.

Need More Help?

In the event that none of the six troubleshooting hacks listed above helped you out to fix 192.168.1.1 not working issue, then without much delay, drop your queries into the comments section.